Справочник Пользователя для SGEG N.A. INC. FBTT528X2
User’s Manual
PM FBT T5 28x2
Application and performance specification
Electronic ballast for T5 28Wx2
Description
Active power factor correction. PF≧0.99
Low harmonic distortion .
Active power factor correction. PF≧0.99
Low harmonic distortion .
THD≦10%
Low lamp current crest factor. CF≦1.6
Warn (Rapid) start.
Long Life
De-active lamp protection
Long Life
De-active lamp protection
Model Line
Volts
Lamp
type
type
Input
watts
watts
Normal
Line amps
Line amps
Power
factor
factor
Total
Harmonic
distortion
Harmonic
distortion
Crest
factor
factor
PMFBTT528x2 120V/60Hz T528W
66W
0.55A
0.99
<10%
<1.6
Performance
Safety
Meets FCC Part 18 (Class A) For EMI
UL listed
Non-consumer
limits
Application:
Physical parameters
Minimum starting temperature -18℃ Mounting
length 226mm
Maximum ambient temperature 40℃
(center
to
center)
Maximum case temperature
75℃
Overall
length
362mm
Width
30mm
Height
26mm
This light device has been tested and found to comply with the limits for Consumer RF Lighting
Device, pursuant to Part 18 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
1. Use only on 120 volt, 60 hertz.
2. Never disassemble or modify - any changes could void the user's authority to operate this device.
3. Not for use in totally enclosed fixtures.
4. Risk of electric shock - do not use where directly exposed to water.
5. This device is not intended for use with emergency exit fixtures or emergency exit lights.
6. This product could produce interference when used near a TV, radio, wireless remote control or
maritime safety communications equipment operating between 0.45-30 MHz. If interference
should occur, move the lamp away from the appliance a distance into a different outlet.
should occur, move the lamp away from the appliance a distance into a different outlet.
7. To prevent burns, do not touch the bulb during operation or immediately after switching off.
8. Not for use with dimmers, electronic timer or photocell devices or occupancy sensor.
Warranty
Universal lighting technologies warrants to the purchaser that each electronics ballast will be marched
with the lamp (T5 28Wx2) and free from defects in material or workmanshop for a period of 5 years
from date of manufacture when properly installed and under normal condition of use.
8. Not for use with dimmers, electronic timer or photocell devices or occupancy sensor.
Warranty
Universal lighting technologies warrants to the purchaser that each electronics ballast will be marched
with the lamp (T5 28Wx2) and free from defects in material or workmanshop for a period of 5 years
from date of manufacture when properly installed and under normal condition of use.