Справочник Пользователя для Redline Communications Inc. AN30

 

 

AN-30 System User Manual 

 

 
The front panel of the AN-30 terminal includes an RJ45 Ethernet interface, four (4) RJ48 
/ BNC E1/T1 interfaces and four (4) grouped status indicators; System, Wireless, TDM 
and Ethernet. The rear of the terminal includes the power cord connector and an F-Type 
female connector for the IF cable. 
 
At power up, an LED power-up sequence occurs as follows: 
 
All three Ethernet LEDs light for one second, then individual Ethernet LEDs blink twice 
in the following order: 100, FD, Link. The Fault LED lights for approximately four 
seconds, then turns off. The two Wireless LEDs remain off for approximately five 
seconds, then blink once and resume their normal state.   
 
A) System Status Indicators 

 

The System portion of the front panel features a recessed reset switch and two LEDs 
(Pwr and Fault), as shown in the figure below.   
 

 

Reset – The system can be manually hard reset by depressing the “Reset” button recessed 
in the front panel.  The reset button is used to reactivate the terminal in the event that it is 
functioning improperly or is in a state of suspension. 
 
Pwr – The  “Pwr” LED lights solid green when the AC power is properly applied to the 
terminal.  In the event of internal power supply failure, if the cord is disconnected,  or if 
the fuse is blown, the “Pwr” light will not illuminate.   
 
Fault – The “Fault” LED lights solid red when a serious fault is detected within the 
system.  
 
B) Wireless Status Indicators 
 
The Wireless portion of the front panel features two LEDs; Link and Signal, as shown 
below. 

 

Page 14 of 80 

Redline Communications