Справочник Пользователя для Redline Communications Inc. AN30
AN-30 System User Manual
encrypt (Encryption Enable): Specifies whether over-the-air encryption is enabled.
Note that if encryption is enabled, it must be enabled on both the local and remote units,
otherwise no Ethernet packets can be transferred.
encryptkey (Encryption Key): Enter the MAC address of the remote terminal to enable
over-the-air data encryption. Note, if encryption is enabled and the MAC address is not
properly entered, no Ethernet packets can be transferred.
buzzer (Alignment Buzzer Enable): Enables the antenna alignment tone sweep
generator located in the T-58 Transceiver for fine tuning using actual signal strength.
Faster repetitions of the tone sweep indicate better alignment.
radio (Radio Enable): Specifies whether radio transmission is enabled.
save config (Save configuration): Saves the currently entered parameters.
test config (Test Configuration): Allows testing of the current settings for five minutes,
after which the system reverts to the previously saved settings. To make settings
permanent, click 'Save’.
reboot (System Reset): Resets all statistics and reboots the terminal.
Note that if encryption is enabled, it must be enabled on both the local and remote units,
otherwise no Ethernet packets can be transferred.
encryptkey (Encryption Key): Enter the MAC address of the remote terminal to enable
over-the-air data encryption. Note, if encryption is enabled and the MAC address is not
properly entered, no Ethernet packets can be transferred.
buzzer (Alignment Buzzer Enable): Enables the antenna alignment tone sweep
generator located in the T-58 Transceiver for fine tuning using actual signal strength.
Faster repetitions of the tone sweep indicate better alignment.
radio (Radio Enable): Specifies whether radio transmission is enabled.
save config (Save configuration): Saves the currently entered parameters.
test config (Test Configuration): Allows testing of the current settings for five minutes,
after which the system reverts to the previously saved settings. To make settings
permanent, click 'Save’.
reboot (System Reset): Resets all statistics and reboots the terminal.
8.3.
CLI General Status Information Commands
The following is a brief description of each field of the CLI General Status Information
sysname (System Name): Identifies the local terminal. The factory default name for the
system is “WEB01”.
sysdetails (System Details): Specifies the location, telephone number and/or contact
information.
ubrate (Uncoded Burst Rate [Mb/s]): Indicates the current uncoded burst rate of the
system. With adaptive modulation, this data rate may change over time, depending on the
prevailing propagation conditions.
master (Master Mode): Indicates if the system is serving as the master or slave.
swver (Software Version): Specifies the software version in use.
starttime (Time Since System Start): Specifies the time [dd/hh/mm/ss] since the
system started.
Page 35 of 80
Redline Communications
…..solving the first mile challenge