Справочник Пользователя для Woosim System Inc. WSP-I450X
WSP-i450 Rev. 6.2
20
FEED button : changing Printer MODE status. (
Power Lamp
)
POWER button : changing OPTION status. (
Error Lamp
)
[Example] The defaults of the printer are :
UART : 9600 bps : 8 data bit : No parity : 1 stop bit : Density low :
Quality low : Mark use : Sensor High : 5 minute
If a user wants to modify the defaults with
Bluetooth : 57,600 bps : 7 data bit : Odd parity : 2 stop bit : Density high :
Quality high : Gap/Hole : Sensor Low : no use
Press FEED & POWER Button during the
Error Lamp
flickers 5 times.
You will see present COMMUNICATION mode in the LCD. (UART)
Press the POWER Button twice. And then, interface mode has set to
Press the POWER Button twice. And then, interface mode has set to
Bluetooth mode.
When you press FEED button once.
You will see present BAUD RATE mode in the LCD. (9600 bps)
Press POWER Button 3 times. And then, BAUD RATE has set to 57,600 bps.
When you press FEED button once.
You will see present DATA BIT mode in the LCD. (8 Data bit)
Press POWER Button once. And then Data Bit has set to 7 DATA BIT.
When you press FEED button once.
You will see present PARITY mode in the LCD. (No parity)
Press POWER Button once. And then the Parity bit has set to ODD Parity Bit..
When you press FEED button once.
You will see present STOP BIT mode in the LCD. (1 stop bit)
Press POWER Button once. And then the density has set to 2 Stop bit.
Press POWER Button once. And then the density has set to 2 Stop bit.
When you press FEED button once.
You will see present DENSITY mode in the LCD. (Density low)
Press POWER Button twice. And then the density has set to Density high.
Press POWER Button twice. And then the density has set to Density high.