Справочник Пользователя для Microsoft Corporation RM-92

FCC Draft

—The user name may be needed to make a data 

connection, and is usually provided by the service provider.

—If you must enter the password every 

time you log in to a server, or if you do not want to save 
your password in the device, select 

.

—A password may be needed to make a data 

connection, and is usually provided by the service provider.

—Select 

 or 

.

—Depending on the access point you are setting 

up, enter the Web address or the address of the multimedia 
messaging center.

Select 

> 

 to change the 

following settings:

—Select the Internet protocol type to use: 

 or 

. The other settings depend 

on the selected network type.

 (for IPv4 only)—Enter the IP address of 

your device. 

—In 

, enter the IP address 

of the primary DNS server. In 

, enter 

the IP address of the secondary DNS server. Contact your 
Internet service provider to obtain these addresses.

—Define the address for the proxy 

server.

—Enter the proxy port number.

Follow the instructions from your service provider.

—Select 

 or 

. If you select an existing network, 

 and 

 are determined by the 

settings of its access point device.

—Select whether the network name 

is shown.

—Select 

 to create an ad hoc 

network and to allow devices to send and receive data 
directly; a wireless LAN access point device is not needed.

—Select the encryption used: 

, 

 (not for ad hoc networks), or 

. If you 

select 

, no encryption is used. The WEP, 

802.1x, and WPA functions can be used only if the 
network supports them.

—Enter the settings for the selected 

security mode:

Security settings for 

:

—Select the WEP key number. You can 

create up to four WEP keys. The same settings must be 
entered on the wireless LAN access point device.

R1113_en.book  Page 97  Friday, November 25, 2005  12:49 PM