Справочник Пользователя для 3e Technologies International Inc. 527A3

3e–527A3 Wireless Access Point – 8 Port

Chapter 5: Wireless Bridge Configuration

29000152-001 B

3e–527A3 Wireless Access Point – 8 Port

Chapter 5: Wireless Bridge Configuration

29000152-001 B

The above recommended setup requires only Bridge 1 to be set in

point-to-multipoint mode. It is possible to set all bridges in point-to-

multipoint mode, in which case , each bridge would have to contain the

BSSID for each of the other bridges and Spanning Tree Protocol must be

Enabled. Complete any other setup screens following general instructions

in Chapter 3.

Repeater Bridge Configuration

A repeater setup can be used to extend the wireless signal from one

bridge connected to an Ethernet LAN wirelessly so that another bridge

can control a wireless LAN at a distance.

��

Repeater Bridging Setup Guide - Manual Mode

Direction

Bridge 1

Bridge 2

Bridge 3

Wireless Bridge — Radio
Wireless Mode

802.11a

Tx Rate

AUTO

Channel No.

Same as Bridge 2

Same as Bridge 1

Tx Power Mode

Auto

Propagation Distance < 5 Miles

< 5 Miles

RTS Threshold

2346

BSSID

Add Bridge 2's MAC Add Bridge 1's and

Bridge 3's MAC

Add Bridge 2's MAC

Wireless Bridge — General (Manual BridgingMode)
Bridging Mode

manual

Signal Strength LED

MAC

Not Assigned (select

from drop-down list)

Not Assigned (select

from drop-down list)

Not Assigned (select

from drop-down list)

Spanning Tree Pro-

tocol

Enable (or Disable

if no bridging loop

possible)

Enable (or Disable

if no bridging loop

possible)

Enable (or Disable if no

bridging loop possible)

Wireless Bridge — Encyption
Wireless Configu-

ration – Bridging

Encryption

Select appropriate

key type/length

and enter key value.

Must be the same as

that on the other two

Bridges.

Select appropriate

key type/length

and enter key value.

Must be the same as

that on the other two

Bridges.

Select appropriate key

type/length and enter

key value. Must be the

same as that on the

other two Bridges.