Справочник Пользователя для 3e Technologies International Inc. 527A3

Wireless Setup allows your computer’s PC Card to communicate with 

the access point. Once you have completed wireless access point configu-

ration, you can complete the rest of the configuration wirelessly unless 

you will be employing the FIPS 140-2 secure mode, assuming that you 

have installed and configured a wireless PC card on your computer. (If 

you have not done so, you will have to do that to establish communica-

tions. Follow the manufacturer's instructions to set up the PC Card on 

each wireless device that will be part of the WLAN.)

 

: The 3e–527A3 is always in FIPS 140-2 secure mode, there-

fore your configuration will have to be accomplished through the 

LAN port due to the secure nature of the access point. There is no 

direct access from wireless clients.

The Wireless Access Point — General screen lists the MAC Address 

of the AP card. This is not the MAC Address that will be used for the BS-

SID for bridging setup, however. That is found on the Wireless Bridge 

 screen.

If you will be using an SSID for a wireless LAN, enter it here and in 

the setup of each wireless client. This nomenclature has to be set on the 

access point and each wireless device in order for them to communicate.