Справочник Пользователя для 3e Technologies International Inc. 527A3

A point-to-point link is a direct connection between two, and only 

two, locations or nodes. Because the bridge function uses a separate 

WLAN card for bridging, you can also set up WLANs on the separate AP 

WLAN card. 

��������

��������

������ �

������ �

�������

�������

�������

For the two bridges that are to be linked to communicate properly, 

they must be set up with compatible commands in the setup screens.

For instance, the bridges must have the same channel number. Be-

cause there is a separate WLAN card for bridging, there can be a separate 

WLAN on the AP WLAN card with no loss efficiency, as long as you set 

the channel numbers so there's no conflict or noise with the channel as-

signed to the bridge. Spanning Tree Protocol may be set to Enable, if there 

is any possibility of a bridging loop, or to Disable (which is more efficient) 

if there's no possibility of a bridging loop. Each bridge must contain 

the other's BSSID. (The BSSID of each is equivalent to the MAC address 

contained on the Wireless Bridge — Radio setup page. Enter only hexa-

decimal numbers, no colons. Data entry is not case sensitive.) Finally, the 

wireless bridging encryption must be set to the appropriate type and key 

length and must be identical on each bridge.

The following charts show sample settings for manual bridging and 

auto bridging modes.