Справочник Пользователя для 3e Technologies International Inc. 531AP
3e-531AP Wireless Access Point
Chapter 5: Bridge Confi guration
29000125-001 C
75
Point-to-Multipoint Bridge Confi guration
A point-to-multipoint confi guration allows you to set up three or
more 3e-531AP access points in bridging mode and accomplish bridging
between 3 or more locations wirelessly.
For the three bridges that are to be linked to communicate properly,
they have to be set up with compatible commands in their setup screens.
For instance, all bridges must have the same channel number. All
must be set for bridging with Wireless Client Access set to Disable and
Spanning Tree Protocol usually set to Enable. If confi gured as in the dia-
gram below, Bridge 1 must contain all of the others' BSSIDs, while Bridge
2 ~ n must only contain Bridge 1's BSSID. (The BSSID of each is equiva-
lent to the MAC address. Enter only hexadecimal numbers, no colons.
Data entry is not case sensitive.) Finally, the wireless bridging encryption
of each must be set to the appropriate type and key length and must be
the same on all.
The following diagram pictures a point-to-multipoint setup, which
might be of use where a company's network spans several buildings
within a campus-like setting.
Ethernet
Ethernet
Bridge 1
Bridge 2
Ethernet
Bridge 3
Ethernet
Bridge 4
Follow the steps of the procedure outlined in the point-to-point bridge
section. The chart below describes the basic attributes.