Справочник Пользователя для Honeywell International Inc. VM2W02
Rev. (a)
Connect Cable - Serial
Note:
Pin 9 of the desired COM port must be configured to provide +5V or RI as needed for the connected device. See the
Thor VM2WG Reference Guide for details.
1. Seat the cable end connector firmly over the serial COM port on the Quick Mount Smart Dock.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Use a strain relief clamp to secure the cable to the Thor VM2WG.
4. Connect the other cable end to the desired serial device.
2. Turn the thumbscrews in a clockwise direction. Do not over tighten.
3. Use a strain relief clamp to secure the cable to the Thor VM2WG.
4. Connect the other cable end to the desired serial device.
Connect a Tethered Scanner
1. The scanner cable is attached to either the COM1 or COM2 port on the Quick Mount Smart Dock.
2. Connect the serial cable for the scanner as directed above.
3. When the Thor VM2WG is powered on, it provides power to the serial scanner.
2. Connect the serial cable for the scanner as directed above.
3. When the Thor VM2WG is powered on, it provides power to the serial scanner.
3-3