Справочник Пользователя для FreeWave Technologies Inc. PRW1001ER
Chapter 7: Diagnostics and Troubleshooting
l
Close and reopen the browser.
l
Try using an alternate browser (e.g., Firefox, Chrome, etc.)
l
The correct login information is used.
l
The factory default User Name is admin and the Password is freewave.
Both are case sensitive.
Verifying the IP address of a Windows® Computer
1. Open a Windows Command Prompt.
2. Issue the command ipconfig.
3. Check the Local Area Connection for:
l
IPv4 Address.
l
Subnet Mask.
If IP address does NOT reside within the same subnet (see example) change the
computer’s IP address to reside within the same network.
Example:
Computer: 192.168.150.3/255.255.255.0.
WavePoint 10: 192.168.1.100/255.255.255.0.
To configure the computer to reside within the same subnet the correct IP
address is 192.168.1.3.
4. Use any unique address within the range that is NOT currently used.
Configuration Changes are not Saving
l
Click Save in the current page before moving to another page.
l
If you navigate to another page without clicking Save, any changes made on that page
are lost.
l
Refresh the web browser window.
l
Changes may have been saved but the browser could be caching the old configuration
and not updating the new settings on the web page.
WavePoint 10e
cannot Obtain an IP address from the ISP
1. Turn off the power to the cable or DSL modem.
2. Turn off the
WavePoint 10e
.
3. Wait 5 minutes, and then turn on the power to the cable or DSL modem.
Page 148 of 171
LUM0063AA Rev 05/05/2014
This document is the property of FreeWave Technologies, Inc. and contains proprietary information owned by
FreeWave®. This document cannot be reproduced in whole or in part by any means without written permission from
FreeWave Technologies, Inc.