Справочник Пользователя для Global Microwave Systems Inc. M2T-D3
100-M0113X1 Rev. 04-17-09 PAGE 21 OF 41
Field
R/W
Description
selected video frame size.
Input Mode
R/W
Choice between Analog SD video or SDI (serial digital
interface). Supports both HD SDI and SD SDI.
interface). Supports both HD SDI and SD SDI.
Analog Video
R/W
Video input format. Desired video input format is
selected from the following values: PAL, NTSC, S-
video PAL, S-video NTSC, and Component Video.
selected from the following values: PAL, NTSC, S-
video PAL, S-video NTSC, and Component Video.
Analog Video
Locked Status
R
Analog video lock status. This read-only field indicates
that the M2T has line-locked onto the SD analog video
input signal [not applicable when the “Input Mode” is
set for SD-SDI or HD-SDI].
that the M2T has line-locked onto the SD analog video
input signal [not applicable when the “Input Mode” is
set for SD-SDI or HD-SDI].
Audio Enable
R/W
Analog audio encoder enable. Desired mode of
operation of the audio encoder is selected from the
following values: Off or On.
operation of the audio encoder is selected from the
following values: Off or On.
Audio Mute
R/W
Choice between mute or un-mute audio stream
Audio Level
R/W
Choice between mic or line level audio
Audio Gain
R/W
Adjustable gain values are adjustable between 0- 100.
Channel Rate
(Mbps)
R
Channel rate is displayed in Mbps and is based on
parameters selected such as C-OFDM mode, FEC and
Guard Interval. See Channel Rate Guide under the
HELP menu.
parameters selected such as C-OFDM mode, FEC and
Guard Interval. See Channel Rate Guide under the
HELP menu.
7.3.3 Pull-Down Menu Definitions
There are several different pull-down menus that are included in the M2T
Configurator program. Each of these pull-down menus contains further user-
configurable options or commands. The following sections describe these
menus in detail.
Configurator program. Each of these pull-down menus contains further user-
configurable options or commands. The following sections describe these
menus in detail.
7.3.3.1 File
You can exit the program by clicking on the ‘X’ box in the upper right hand
corner or by clicking on the ‘File’ menu and choosing ‘Exit’. You can save
the settings before exiting by clicking on the ‘Store All Setup Pages’ button
on the front page or by choosing the ‘Save Parameters’ under the ‘File’
menu.
corner or by clicking on the ‘File’ menu and choosing ‘Exit’. You can save
the settings before exiting by clicking on the ‘Store All Setup Pages’ button
on the front page or by choosing the ‘Save Parameters’ under the ‘File’
menu.
7.3.3.2 Configuration
This pull-down menu (reference Figure 6) contains several different
configuration options. These are outlined below:
configuration options. These are outlined below: