Справочник Пользователя для RF Ideas Inc LC80XW6
©2015 RF IDeas
Configuration Utility User Manual
P a g e
|
40
High Priority: Provides a pcProx Plus user the ability to give a certain configuration a higher priority
than another. This is useful when the user has a population of cards consisting of a combination of 13.56
MHz/125kHz cards as well as single-technology cards, and one of those is preferred over the other.
When the High priority feature is enabled, the reader will try to read that card type 10 times before
switching to the other configuration.
switching to the other configuration.
3.6 Connect Tab
Image 49: Connect Tab
The Connect tab offers various ways a device can connect to the configuration utility. The different
selections allow the user to choose the connection type for the specific logical protocol of their reader.
selections allow the user to choose the connection type for the specific logical protocol of their reader.
Only one connection type at a time will be shown.
USB: Make this selection if the connected device has a USB logical protocol. The utility will then proceed
to scan any available USB bus for connected devices.
to scan any available USB bus for connected devices.
Serial RS-232 and Virtual COM Ports: This option provides devices that are RS-232 or Virtual COM
port logical protocols to connect to the utility. This section scans for RS-232, CDC, and PCMCIA
devices.
port logical protocols to connect to the utility. This section scans for RS-232, CDC, and PCMCIA
devices.
When making this selection, the lower and upper limits of the COM ports to scan need to be set.
The port values range from 1 to 256. The default COM ports are set at 1 through 8.
The port values range from 1 to 256. The default COM ports are set at 1 through 8.
Default 1.8: This option sets the COM port values back to the default of 1 and 8.