Справочник Пользователя для Kenwo Industries Limited ARI60

Note: Connect the (HAR-1) harness to the MCM only after installation is completed. If the

battery is to be removed, disconnect this connector first. Reconnect only after battery

terminals are reconnected.

Note: When the main harness (HAR-1) is plugged in, the siren should chirp. If the siren dose

not chirp; check the fuse, and battery (+) and ground (-) connections.

Setting Clock Time

1. Enter the programming mode.
2. Press button #4 repeatedly until the

icon begins to flash.

3. Press button #1 to select and enter clock setting mode.
4. Press button #1 to scroll through ‘hour’, ‘minute’, ‘am/pm’ settings. The

selected item will be flashing.

5. Press button #2 to adjust the setting of the selected item.
6. Press button #4 to save setting and exit, or press button #3 to abort.

Encoding a Transceiver

1. Unplug HAR-1 from the MCM and plug it back in, the siren will chirp 2 times and

the lights will flash 2 times.

2. Within

6 seconds turn ignition switch “ON” and “OFF” 3 times.

3. If step 3 is done correctly and within the time allowed , the siren will chirp 2

times and the lights will flash an additional 2 times to confirm that the system is

in “Learn Mode”

4. Press and hold button # 1 until the system chirps 2 times and the lights flash 2

times to indicate that the MCM has learned the code.

5. The Transceiver echoes 4 chirps and the LCD displays [LErn donE] to confirm

that the Transceiver is encoded.

6. Turn ignition “ON” and “OFF” to exit “Learn Mode”

This Section purposely left blank

Connections

Fuse

To Battery (+)

Accessory
HAR-1 Connector

GEN-1

MCM

Black – To Ground (-)

Grey – To Turn Signal

                                                                                                                      Grey – To Turn Signal
                                                                                                                      Orange – To Tail Light

Using the T-tap Connectors

1) Place female T-tap connector over wire to be tapped, close and squeeze until it

snaps close. 2) Now slip male T-tap connector over hinged end of the female
connector to make a connection.

Motorcycle Wire

Female T-tap

                          Male T-tap
   Motorcycle
       Wire

Wire from (GEN-1)

Note: Transceivers are programmed from the factory. Encoding is only necessary should the

Transceiver looses its codes and will not arm or disarm the security system or if a second
or replacement remote is obtained.