Справочник Пользователя для CyberTAN Technology Inc. WR114
Broadband Wireless Router User Guide
- 17 -
17
Specify WAN IP Address Enter the IP address provided by your ISP.
Subnet Mask Enter the subnet mask values provided by your ISP.
Default Gateway IP Address Your ISP will provide you with the Default
Gateway IP Address.
Domain Name Server (DNS) Your ISP will provide you with at least one
DNS IP Address. Multiple DNS IP settings are common. The first available
DNS entry is used in most cases.
DNS entry is used in most cases.
PPPoE
PPPoE is a dial-up connection type provided by some ISPs. It is a cost–effective
way for a user to access this connection type. If your ISP provides PPPoE
connectivity, you should choose this item from the drop-down list. Note that if
you select PPPoE, please remove any existing PPPoE application on any PCs on
your LAN.
way for a user to access this connection type. If your ISP provides PPPoE
connectivity, you should choose this item from the drop-down list. Note that if
you select PPPoE, please remove any existing PPPoE application on any PCs on
your LAN.
User Name Enter the user name your ISP provides you.
Password Enter the password your ISP provides you.
Connect-on-demand is a utility used to trigger the PPPoE session when
there is packet being sent through the WAN port while it is on disconnected
situation. Check the radio button to make this function active, and then you
must enter the number of minutes you wish the network to remain idle
before disconnection occurs in the “Max Idle Time” location. Note that this
function is for PPPoE only.
situation. Check the radio button to make this function active, and then you
must enter the number of minutes you wish the network to remain idle
before disconnection occurs in the “Max Idle Time” location. Note that this
function is for PPPoE only.
Keep Alive This function keeps your PPPoE connection enable even if it
remains idle. However, in some situation, PPPoE session cannot be
established immediately after disconnection. This is because the system on
the ISP’s site may need a little time to restore itself. You may need to check
with your ISP to obtain detail of how long you need to wait before
re-establish the PPPoE session. Enter this information in the “Redial
Period” field.
established immediately after disconnection. This is because the system on
the ISP’s site may need a little time to restore itself. You may need to check
with your ISP to obtain detail of how long you need to wait before
re-establish the PPPoE session. Enter this information in the “Redial
Period” field.
PPTP
PPTP is the acronym of Point to Point Tunneling Protocol. Usually, it is used to
encapsulate other protocols’ packets for transmission over IP network. Some
ISPs use this protocol as way to establish the initial connection between the CPE
encapsulate other protocols’ packets for transmission over IP network. Some
ISPs use this protocol as way to establish the initial connection between the CPE