Справочник Пользователя для Cleveland Medical Devices Inc. 0007
BioRadio 110 User Guide
Cleveland Medical Devices Inc.
6
Connecting the Receiver
1. Connect the Receiver to a laptop or desktop computer using the Receiver data cable.
The small end of the 3-foot cable fits into the jack on the bottom of the Receiver.
You will hear two clicks when properly attached. The 9-pin end fits into your
computer’s available RS-232 serial port. Use the 6-foot DB-9 extension to add
length to the 3-foot cable.
Note which port is used; (COM1, COM2, etc.) for configuration of the software.
Refer to your PC’s manual for information on setting up COM ports.
If the only available port is a 25-pin port, you will need to use a 25-9 pin adaptor
(not provided but available at most electronic stores).
You will hear two clicks when properly attached. The 9-pin end fits into your
computer’s available RS-232 serial port. Use the 6-foot DB-9 extension to add
length to the 3-foot cable.
Note which port is used; (COM1, COM2, etc.) for configuration of the software.
Refer to your PC’s manual for information on setting up COM ports.
If the only available port is a 25-pin port, you will need to use a 25-9 pin adaptor
(not provided but available at most electronic stores).
2. Power the Receiver by:
•
plugging in the AC adapter power cord (primary power source, typically used for
desktop applications), or
desktop applications), or
•
attaching a 9-volt battery via the 9-volt battery adaptor wire plug (typically used
for mobile laptop applications)
for mobile laptop applications)
To RS-232 serial port
To power supply
392-0000rev1.pub
page 6
page 6
Thursday, November 12, 1998 15:39