Справочник Пользователя для Wistron NeWeb Corporation UMC-6055Q
Product specification
3
1.
INTRODUCTION
This document describes the hardware interface of the WNC Small Form Factor (SFF) module used to connect
the device application and the air interface.
Two versions of Small Form Factor (SFF) module are described in this specification document as follows:
UMC-6055QV - CDMA2000 1X
1.1
PRODUCT CONCEPT
The SFF module is one of the smallest available CDMA2000 1X modules of the market. The target application
is the Machine to Machine (M2M) market including automotive, AMM (Automatic Metering Management),
tracking system, Alarm, Healthcare/monitoring, Telematics etc. Despite its small size and cost,
In addition to its size it has the following outstanding characteristics:
Minimum low power consumption in idle mode: 1.4mA
High input voltage range: 3.4 V to 4.2 V
USB High Speed
Digital Audio PCM
Full set of AT commands as well as analogue and Digital audio interface.
In addition to the module, a complete development kit can be provided for customers.
1.2
STANDARDS
This product, together with its evaluation board, is in compliance with the directives and standards listed below:
Directives
Directives
FCC
RF : FCC Part 22H (850 Band )
FCC Part 24E (for 1900 Band)
FCC Part 22 Subpart H:
Cellular Radiotelephone Service; Subpart I: Offshore
Radiotelephone Service;
FCC Part 24 E: Personal Communications Service; Subpart E:
Broadband PCS.
EMI: FCC Part 15B
Subpart B - Radio frequency devices subpart B – Unintentional
Radiators
SAR(MPE) : OET65C