Справочник Пользователя для ARRIS Global Limited ND7507

ND7506 USER GUIDE

Full details of the rear panel are on page 6.
Connecting
Do not connect your set-top box (or any other equipment such as a TV or 
DVD player) to the power supply until you have properly connected all the 
other cables.

Your set-top box is designed for use only with the power supply unit provided.

On the power supply unit there is a label that specifies the correct AC 
power supply input for it. Do not connect the power supply unit to any 
supply other than this.

Always connect the 12 volt DC cord from the power supply unit to your 
set-top box before you insert the AC power cord from the power supply 
unit into the wall AC outlet.
Disconnecting
To disconnect power from your set-top box, always detach the power 
supply unit from the wall AC outlet (rather than remove the 12 volt cord 
from your set-top box). Therefore you must install your set-top box near to 
the wall AC outlet, which should be easily accessible.

If you are in any doubt about the power supply cord, its plug or its connection, 
or are not certain that the electrical outlets you are using are properly wired 
and grounded, consult a qualified electrician before proceeding any further.

This device complies with Part 15 of the FCC Rules. Operation is subject to the 

following two conditions: 

(1) this device may not cause harmful interference, and  

(2) this device must accept any interference received, including interference that 

may cause undesired operation. 
This equipment complies with FCC radiation exposure limits set forth for 

an uncontrolled environment. End users must follow the specific operating 

instructions for satisfying RF exposure compliance. This transmitter must not be 

co-located or operating in conjunction with any other antenna or transmitter. 
Changes or modifications not expressly approved by the party responsible for 

compliance could void the user’s authority to operate the equipment.
FCC RF Radiation Exposure Statement
MPE/SAR/RF Exposure Information. 
This equipment complies with FCC RF radiation exposure limits set forth for an 

uncontrolled environment.
This equipment was verified for RF exposure and found to comply with Council 

Recommendation 1999/519/EC and FCC KDB 447498 D01 General SAR 

Exclusion Guidance.
WARNING: While this equipment is in operation, a separation distance of at 

least 20 centimetres (equal to 8 inches) must be maintained between the antenna 

inside the equipment and the bodies of all persons exposed to the antenna in 

order to meet the FCC RF exposure guidelines. Making changes to the antenna 

or the equipment is not permitted. Doing so may result in the equipment 

exceeding the FCC RF exposure guidelines. This equipment must not be co-

located or operated in conjunction with any other antenna or radio transmitter.
NOTE: Your set-top box has been tested and found to comply with the limits 

for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits 

are designed to provide reasonable protection against harmful interference 

in a residential installation. Your set-top box generates, uses and can radiate 

radiofrequency energy and, if not installed and used in accordance with the 

instructions, may cause harmful interference to radio communications. However, 

there is no guarantee that interference will not occur in a particular installation. If your 

set-top box does cause harmful interference to radio or television reception, which 

can be determined by turning your set-top box off and on, you are encouraged to try 

to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between your set-top box and the receiver.
• Connect your set-top box to an outlet on a circuit different from that to which 

the receiver is connected.
• Consult your dealer or an experienced radio/TV technician for help.
WIFI
Users should be advised that high-power radars are allocated as primary users 

(i.e. priority users) of the bands 5250-5350 MHz and 5470-5725 MHz and that 

these radars could cause interference and/or damage to the LE-LAN device.
The device for operation in the band 5150-5250 MHz is only for indoor use 

to reduce the potential for harmful interference to co-channel mobile satellite 

systems.