Справочник Пользователя для Telematics Wireless Ltd. T210A

Warning: There must be a permanent ground from the main power source to the DCU2 Pro E
US. Whenever it is likely that the protection has been impaired, disconnect the power cord until
the ground has been restored.

6.6.

Preparing Android Smartphone

A smartphone app provided by Telematics is required for scanning the DCU2 Pro E US barcode and
testing its connection to the CMS.

How to prepare smartphone:

1. On an Android smartphone with a camera:

a) Enable network connectivity.
b) Download and install the DCU Checkup app which your Telematics representative will

provide.

2. Open the DCU Checkup app and input the license key received from Telematics.

Entering the license key before the installer uses the app in the field will save the installer from
having to remember the key.

7. Installing the DCU2 Pro E US on a Light Pole

The general steps are:



Installing the circuit breaker, if not already installed.



Physical placement and securing of the DCU2 Pro E US on the pole.



Installing the antennas.



Drilling a hole for the grommet and power cable.



Inserting DCU2 Pro E US 12 m power cable through grommet and into the pole



Connecting theDCU2 Pro E US power cable to the circuit breaker.



Scanning the barcode and testing the data communication using the prepared smartphone.

To install the DCU2 Pro E US:

1. Turn the pole power OFF.
2. Position the DCU2 Pro E US on the pole as follows:

◦

The DCU2 Pro E US should be installed at the highest possible point on the pole, as approved by
Telematics.

◦

Position the DCU2 Pro E US so that the Tnet antenna with TNC connector will face upwards, in
order to provide the greatest line-of-sight for the end units as possible.

Note: If the location of the Tnet antenna will not provide a reliable line-of-sight for the end units,
contact Telematics for assistance.

3. Thread the steel tape through the slots in the upper and lower mounting brackets.