Справочник Пользователя для Given Imaging Limited SMARTPILL
Appendix: Electrical Safety
3UHSDULQJIRUD7HVW
Before the Test Day
Fully charge the data receiver the day or night before starting a test. Charging can take
up to 5 hours.
Charging the Data Receiver
1. Ensure that the data receiver is off. If any characters appear on the display, turn off
1. Ensure that the data receiver is off. If any characters appear on the display, turn off
the data receiver by simultaneously pressing the 2 buttons on the front of the unit
for approximately 5 seconds.
for approximately 5 seconds.
Caution
The data receiver must be turned off during charging. Charging the data receiver while turned on results in a
partial charge. You may lose test data.
2. When the back light dims, release both buttons.
3. Plug the docking station into an electrical outlet.
3. Plug the docking station into an electrical outlet.
►
If necessary, use a power adapter.
4. Firmly push the data receiver into the docking station to initiate charging. The
docking station’s LED turns red.
Figure 3
x Allow up to 5 hours for the data receiver to fully charge.
x The docking station’s LED turns green when the data receiver is fully charged.
x The docking station’s LED turns green when the data receiver is fully charged.
Caution
Charging or recharging the data receiver with a power source other than the SmartPill power supply may
permanently damage the data receiver, docking station, or system computer and will void the product
warranty.