Справочник Пользователя для Inovonics Wireless Corporation 3B6AVBLP
2
Installation Steps — cont.
8. Make sure jumpers in Base are configured to match your installation (see Base Station Controls dia-
gram)
8. Make sure jumpers in Base are configured to match your installation (see Base Station Controls dia-
gram)
•
J1 & J2 — Separate speaker & mic or one device serving as both
•
J4 — Detection type: closure or pulse
•
J5 — Full-duplex or Standard (half-duplex)
•
J6 — Full-duplex click suppression
9. Turn on power to base
10. Insert batteries in belt-packs and program per instructions on programming station
11. Connect headsets to belt-packs and test range, reception, audio quality, and volume
12. Adjust volume levels as needed
13. Test vehicle detection
14. Train restaurant employees and manager
QSR Drive Thru Solutions - Batteries & Charger
Charging Indicators — Will light red
when battery is charging and change
to green when battery is charged
Charging Ports for
Batteries
Holes for Wall
Mount Screws
NOTES:
• Batteries are Lithium-Ion
• Batteries require about 3 hours to charge
• Batteries will hold a charge for about 8 to 10 hours during normal use
• When the battery voltage becomes too low, a short warble tone, occurring at five–second
• Batteries require about 3 hours to charge
• Batteries will hold a charge for about 8 to 10 hours during normal use
• When the battery voltage becomes too low, a short warble tone, occurring at five–second
intervals is heard in the headset. After 2 minutes the headset will shut off.
• Batteries should be removed from belt-pack and stored in charger when not being used.