Справочник Пользователя для Inovonics Wireless Corporation 3B6OT9RTX

4/11/14 05596E_v1 © Inovonics, 2014 - www.inovonics.com

To activate single button transmitters, press the button for at least 
one second. To activate double button transmitters, press both 
buttons simultaneously. Alarm signals are transmitted multiple times 
and are indicated by the blinking transmission LED. When the 
buttons are released, the transmitter sends an alarm restoral 
signal.To test a transmitter, activate the alarm by pressing the 
button(s).

Replacement batteries can be purchased from Inovonics using the 
following part numbers:

• BAT608 for a single battery

To replace the battery:
1. Pry the housing apart at either end and pull the two halves 

apart.

2. Install the battery.
3. Press the reset button to initialize the transmitter.

The transmitter should be tested weekly and after registration to 
ensure operation.
To test the transmitter:
1. Activate the transmitter and ensure the transmit LED lights and 

the alarm is received by the receiver or gateway.

2. Press the reset button and ensure the transmit LED lights.

Typical battery life: 3-5 years
Battery type (BAT608): Panasonic CR2 or equivalent
Operating environment: 0 to 60°C (32 to 140°F), noncondensing

Note: Specifications and data are subject to change without notice.

This equipment has been tested and found to comply with the limits 
for a Class B digital device, pursuant to Part 15 of the FCC Rules. 
These limits are designed to provide reasonable protection against 
harmful interference in a residential installation. This equipment 
generates, uses and can radiate radio frequency energy and, if not 
installed and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, there is no 
guarantee that interference will not occur in a particular installation.  
If this equipment does cause harmful interference to radio or 
television reception, which can be determined by turning the 
equipment off and on, the user is encouraged to try to correct the 
interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from 

that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for 

help.

This equipment complies with FCC radiation exposure limits set 
forth for an uncontrolled environment. End users must follow the 
specific operating instructions for satisfying RF exposure 
compliance. This transmitter must not be co-located or operating in 
conjunction with any other antenna or transmitter except in 
accordance with FCC multi-transmitter product procedures.

This device complies with part 15 of the FCC Rules and Industry 
Canada license-exempt RSS standard(s). Operation is subject to 
the following two conditions: (1) this device may not cause 
interference, and (2) this device must accept any interference, 
including interference that may cause undesired operation of the 
device.
Le présent appareil est conforme aux CNR d'Industrie Canada 
applicables aux appareils radio exempts de licence. L'exploitation 
est autorisée aux deux conditions suivantes : (1) l'appareil ne doit 
pas produire de brouillage, et (2) l'utilisateur de l'appareil doit 
accepter tout brouillage radioélectrique subi, même si le brouillage 
est susceptible d'en compromettre le fonctionnement.

Note: Changes or modifications not expressly approved by the 
party responsible for compliance could void the user's authority to 
operate the equipment.

• 7,154,866
• 7,554,932
• 7,746,804