Справочник Пользователя для Honeywell International Inc. 9500LUPE

Using the Charge/Analyze slot helps you monitor the charge capacity of Li-ion batteries over time.

The battery analyzer is located in the fourth slot - named the Charge/Analyze slot - of the ChargeBase. Only a battery 
placed in this slot can be run through an Analyze cycle. This slot contains Battery Capacity LEDs along the right side.

The Analyze cycle is initiated when a battery is placed in the Charge/Analyze slot and the ANALYZE button is 
pressed. In an Analyze cycle, batteries are completely discharged, then recharged to capacity. The length of time it 
takes for a battery to complete the Analyze cycle varies depending on the initial state of the battery’s charge. Minimum 
time is 8 hours, maximum time is 12 hours.

The Battery Capacity LEDs are located along the right side of the Charge/Analyze slot. Each LED equates to 10% 
battery capacity. These LEDs display the capacity of the battery at the end of the Analyze cycle. Battery capacity is 
displayed as a percentage of measured capacity/rated capacity. 

The Charge/Analyze slot also contains a standard status LED in the upper, left corner of the slot. When this slot is 

used for regular charging, this LED operates in the usual manner; see 

When this slot is being used to analyze a battery, the Status LED functions as follows:

1. Insert the battery into the Charge/Analyze slot (the fourth).

2. Press the ANALYZE button. The Status LED flashes orange to indicate that the analyzing cycle has begun.

3. Upon completion of the Analyze cycle, the Status LED lights solid green, and the Battery Capacity Indicator LEDs display 

the battery’s capacity.

You can verify a battery’s capacity by installing the battery in a terminal and checking the power; see 

Solid Green

Has completed the Analyze cycle. 

Flashing Orange

Is being analyzed. 

Solid Red

Encountered an error during the Analyze cycle.

!