Справочник Пользователя для Rohde & Schwarz Inc SLV8000
Chapter 5
Operating
2100.4400.32
- 5.55 -
E-2
5.2.2
TV Settings > Input > Receiver / Receiver AUX > TPS
If the receiver in the TV Settings > Input > Receiver (or Receiver AUX) > Setup menu
displays OK in the Rx OK field, the DVB-T/H parameters it has determined are listed and
valid at this point.
displays OK in the Rx OK field, the DVB-T/H parameters it has determined are listed and
valid at this point.
5.2.3
TV Settings > Input > Receiver / Receiver AUX > Status
This menu displays the measured values of the associated receiver module.
Setting item
Description
Enable Hierarchy
Prepares receiver module for hierarchical coding mode
Two receiver modules are needed for the Retransmitter function with
hierarchy. Module 1 analyzes the HP component in the RF input signal
and transfers the associated high priority stream to the exciter. Module 2
(auxiliary) analyzes the LP component and delivers the low priority
stream for the exciter.
hierarchy. Module 1 analyzes the HP component in the RF input signal
and transfers the associated high priority stream to the exciter. Module 2
(auxiliary) analyzes the LP component and delivers the low priority
stream for the exciter.
RF Frequency
Center frequency of the DVB-T/H signal fed to the antenna input of the
receiver module.
receiver module.
Bandwidth
Channel bandwidth (6, 7 or 8 MHz)
RF Attenuation
Antenna
Antenna
Manual input attenuation (0 dB to 31 dB)
This value should be adapted to suit the expected input level.
BER Threshold
Fault threshold for the bit error ratio (measured after the Viterbi decoder)
PER Threshold
Fault threshold for the packet error ratio
Display
Description
Rx OK
Status reporting for the DVB-TH receiver:
– W: Warning, receiver has no valid input signal
– OK: Receiver has a valid input signal
– W: Warning, receiver has no valid input signal
– OK: Receiver has a valid input signal