Справочник Пользователя для Rohde & Schwarz Inc SLV8000

2100.4400.32

- 5.84 -

E-2

Regeneration

Used to switch sync-pulse regeneration on or off

Sync Amplitude

Used to set the amplitude of the regenerated sync pulse (with regenera-
tion switched on)

Sync Monitoring

Indicates the status of sync-pulse monitoring of the input signal. The fol-
lowing may be displayed:
– OK: A standard input signal is being applied
– no V: No V-pulse frame detected
– no H+V: No V and H-pulse frame detected
– too low: Sync-pulse amplitude is less than 50% of the nominal sync-

pulse amplitude; the processed signal is, however, available at the 
encoder output

Sync Amplitude Input

Displays the measured input amplitude [mV] of the sync pulse. If the 
selected scanning line is not found in the input signal, the measurement 
value 0 mV is displayed.

Sync Amplitude 
Output

Displays the measured output amplitude in [mV] of the sync pulse

Diplexer

Used to switch the diplexer pre-equalization (diplexer peaking) on or off