Справочник Пользователя для Rohde & Schwarz Inc SLV8000
Chapter 3
Installation
2100.4400.32
- 3.1 -
E-2
1
Unpacking and Setting Up
1.1
Equipment Supplied
The following items are supplied as standard:
R&S SLx8000 low-power transmitter in one of the following versions:
– R&S SLV8002: 2 HU, band IV/V
– R&S SLV8005(A): 2 HU, band IV/V
– R&S SLV8010(A): 2 HU, band IV/V
– R&S SLV8025(A): 3 HU, band IV/V
– R&S SLW8025(A): 3 HU, band III
– R&S SLV8050(A): 3 HU, band IV/V
– R&S SLW8050(A): 3 HU, band III
– R&S SLV8100(A): 3 HU, band IV/V
– R&S SLW8100(A): 3 HU, band III
– R&S SLV8002: 2 HU, band IV/V
– R&S SLV8005(A): 2 HU, band IV/V
– R&S SLV8010(A): 2 HU, band IV/V
– R&S SLV8025(A): 3 HU, band IV/V
– R&S SLW8025(A): 3 HU, band III
– R&S SLV8050(A): 3 HU, band IV/V
– R&S SLW8050(A): 3 HU, band III
– R&S SLV8100(A): 3 HU, band IV/V
– R&S SLW8100(A): 3 HU, band III
Power cable (DC options: non-assembled at one end)
Short-circuit connector for
X32
This user manual
Note
The performance data for these transmitter variants is given in the section "Power Classes"
in the chapter "Design and Function".
in the chapter "Design and Function".
1.2
Unpacking Instrument
Carefully remove the instrument from the carton and check the delivery for complete-
ness against the delivery note.
ness against the delivery note.
1.3
Setting Up Instrument
The instrument can stand on its feet or be built into a 19“ rack. Depending on which model
is selected, 2 or 3 height units are required for installation in a 19" rack.
is selected, 2 or 3 height units are required for installation in a 19" rack.
Note
Make sure the instrument is standing in a stable position and there is sufficient ventilation.
Make sure in particular that the flow of air through the inlets on the front panel and the out-
lets on the rear panel (fan) is not obstructed.
Make sure in particular that the flow of air through the inlets on the front panel and the out-
lets on the rear panel (fan) is not obstructed.