Справочник Пользователя для Quanta Computer Inc LM177
Page 30
6.
OMA-DM
6.1.
Mandatory Configuration
1.
It’s necessary to configure Quanta device with
the following parameters before you start
OMA-DM testing.
the following parameters before you start
OMA-DM testing.
2.
It’s mandatory to configure Quanta device
with the following parameters if your device is
upgraded to new firmware.
with the following parameters if your device is
upgraded to new firmware.
3.
Please make sure that the device is not
connected to LTE network (i.e. offline from
eNodeB) before you do any configuration.
connected to LTE network (i.e. offline from
eNodeB) before you do any configuration.
4.
Please open connection manager.
5.
Please enter the following AT commands
sequentially (Please refer section 3.1.2).
sequentially (Please refer section 3.1.2).
AT%
S
ETCFG="enable_test_mode","0"
AT%
S
ETCFG="vzw_mode","1"
AT%
S
ETACFG=ecm.Mode.VzwMode,true
AT%
S
ETACFG=ecm.Mode.VzwImsTestMode,false
6.
Please check if it returns “OK”.
7.
Please confirm your configuration by entering
the following AT commands sequentially.
the following AT commands sequentially.
AT%
G
ETCFG="enable_test_mode"
(it shall be “0”)
AT%
G
ETCFG="vzw_mode"
(it shall be “1”)
AT%
G
ETACFG=ecm.Mode.VzwMode
(it shall be “true”)
AT%
G
ETACFG=ecm.Mode.VzwImsTestMode
(it shall be “false”)