Справочник Пользователя для Unitech Electronics Co. Ltd. MS842RBBT
- 89 -
© 2017 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co., Ltd.
MS842RB User’s Manual
4.8.2 Data Format Editor Commands
When working with the Data Format Editor, a virtual cursor is moved along
your input data string. The following commands are used to both move
this cursor to different positions, and to select, replace, and insert data into
the final output.
4.8.2.1 Send Commands
■ Send all characters
F1 Include in the output message all of the characters from the input
message, starting from current cursor position, followed by an insert
character. Syntax = F1xx where xx stands for the insert character’s
hex value for its ASCII code. Refer to the
■ Send a number of characters
F2 Include in the output message a number of characters followed by an
insert character. Start from the current cursor position and continue
for “nn” characters or through the last character in the input message,
followed by character “xx.” Syntax = F2nnxx where nn stands for the
numeric value (00-99) for the number of characters, and xx stands
for the insert character’s hex value for its ASCII code. Refer to the
, for decimal, hex and
character codes.
F2 Example: Send a number of characters
Send the first 10 characters from the bar code above, followed by a
carriage return. Command string:F2100D
F2 is the “Send a number of characters” command
10 is the number of characters to send
0D is the hex value for a CR
The data is output as: 1234567890