Справочник Пользователя для Unitech Electronics Co. Ltd. MS916BT
- 33 -
Time-out Between Same Symbol
Parameter # 0x89
When in Continuous triggering mode, this parameter sets the minimum time
that must elapse before the scan engine decodes a second bar code identical
to one just decoded. This reduces the risk of accidently scanning the same
symbol twice. It is programmable in 0.1 second increments from 0.0 to 9.9
seconds.
To set a time-out between same symbol, scan the bar code below. Next scan
two numeric bar codes beginning on page 77 that correspond to the desired
time-out. Single digit values must have a leading zero. For example, to set a
time-out of 0.5 seconds, scan the bar code below, then scan the “0” and “5” bar
codes. To change the selection or cancel an incorrect entry, scan Cancel on
page 78.
Beep After Good Decode
Parameter # 0x38
Scan this symbol to set the scan engine to beep after a good decode.