Справочник Пользователя для Intermec Technologies Corporation RM182-24

Place this supplement in your manual.
This device complies with Part 15 of the FCC Rules and with RSS-210 of

Industry Canada. Operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) This device must accept any

interference received, including interference that can cause undesired

operation.

This equipment is intended for operation in a commercial environment, in

compliance with the requirements for a Class A digital device, pursuant to Part

15 of the FCC Rules, and it must not be used in a residential environment;

however, it has also been tested and found to comply with the more stringent

requirements for a Class B device, pursuant to Part 15 of the FCC Rules. It

generates, uses, and can radiate radio frequency energy. If not installed and

used in accordance with the instruction manual, it may cause interference to

radio communications. If this equipment causes interference, the user will be

required to correct the interference at the user’s own expense.

To comply with the FCC’s RF exposure requirements and minimize health

hazards:
The user shall not touch the antenna of this device, when the device is in use

, where low gain antennas are used.

In some products (Models 2415 and 6400), the antena is inside the product. In

other products the antenna is a small dipole usually attached to the side or to

the top of the product.
With handheld devices, the user shall ensure that the device is at least 20 cm (8

inches) away from their body, when the transceiver is in use.
The user shall stay at least 20 cm (8 inches) away from the antenna of this

device, when the device is in use in access points and other hosts , where

higher gain antennas may be used.