Справочник Пользователя для Honeywell International Inc. RV8310

When the control is in the AUTO mode, the main burner will turn on/off or modulate
based on the heat needed to maintain the set temperature.  The flame level will change
automatically to optimize the heat output needed to maintain the set temperature. To
change the set temperature, press the up or down key. Pushing a key once will change the
temperature by one degree.

In the AUTO mode the fan speed will increase with increasing flame height or decrease
with decreasing flame height. “AUTO” is displayed next to the flame and fan icons.

If a lower or higher fan speed is desired when operating in the AUTO mode, the fan speed
can be overridden by pushing the fan button followed by the up or down key. Pushing a
key once will change the fan level by one unit. In this mode “AUTO” is displayed next to
the flame icon and “MANUAL” is displayed next to the fan icon.

Push the up and down arrow keys simultaneously for at least 3 seconds to toggle between
F and C units.

To disable the thermostat function in the AUTO mode, push the time and down keys
simultaneously for at least 3 seconds.

1.  Remove cover on the backside of the transmitter. Install 3 AAA batteries and as

shown and reattach cover.

2.  Once steps 1-3 in RV8310D Operation have been completed, receiver/valve and

transmitter are now ready. Press any button on transmitter for recognition process to
occur between the receiver/valve and transmitter.

3.  Use functions as described in TRANSMITTER section.

Copyright Draft 1999 Honeywell, Inc. – All Rights Reserved

Home and Building Control
Honeywell, Inc.