Справочник Пользователя для InFocus Corporation HWLBWAND02
1
LiteBoard™ Wand
The LiteBoard™ Wand works like a wireless mouse - but one that works in
midair, not on your desktop. Just hold the wand in your hand, and point it at the
projected image to point, click and drag. The wand works with all your software,
just like a regular mouse.
midair, not on your desktop. Just hold the wand in your hand, and point it at the
projected image to point, click and drag. The wand works with all your software,
just like a regular mouse.
Charging the Wand’s Battery
When the wand’s red battery light starts to blink, its internal battery is low.
To charge the battery, open the flap at the side of the wand to expose the wand’s
USB connector. Then connect a USB cable between the wand and a computer
(make sure the computer is powered on). The battery light will stay on while the
battery is charging, then it will turn off when the battery is fully charged.
When charging is finished, disconnect the USB cable.
NOTE: The charging time will take approximately 3 hours and will allow more
than 25 hours of wand use. Do not use the wand while the wand’s battery is
charging.
Caution: The lithium battery is only rechargeable, and is not user serviceable or
user replaceable.
Caution: Always use the included USB cable and your computer to charge the
wand.
To charge the battery, open the flap at the side of the wand to expose the wand’s
USB connector. Then connect a USB cable between the wand and a computer
(make sure the computer is powered on). The battery light will stay on while the
battery is charging, then it will turn off when the battery is fully charged.
When charging is finished, disconnect the USB cable.
NOTE: The charging time will take approximately 3 hours and will allow more
than 25 hours of wand use. Do not use the wand while the wand’s battery is
charging.
Caution: The lithium battery is only rechargeable, and is not user serviceable or
user replaceable.
Caution: Always use the included USB cable and your computer to charge the
wand.
How to Use the Wand
1
The projector needs to be powered on and connected to your computer.
2
Connect the projector and your computer with a USB cable.
3
Connect the projector and your computer with a VGA cable.
4
Make sure the wand's battery is charged or charging.
5
Turn on the projector and make sure it's displaying the computer's screen -
set the source to Computer 1 or Computer 2 (press the source button on the
projector or its remote if needed - you may need to press it several times).
set the source to Computer 1 or Computer 2 (press the source button on the
projector or its remote if needed - you may need to press it several times).
6
Enable the LiteBoard™ Wand in the Advanced Menu > Setup > Keypad/
Remote menu.
7
Turn on the wand by pressing its tip - the wand's blue status light will start to
blink.
blink.
8
Point the wand at the screen to point, click, and drag - just like a normal
mouse.
mouse.
NOTE: When you’re done, set the wand aside and make sure it isn’t pointing at
the screen; it will turn itself off automatically after 1 minute.
the screen; it will turn itself off automatically after 1 minute.
Wand Position and Avoiding Shadows
Your Location Distance from the Screen
You can use the LiteBoard™ Wand right up against the screen, or around the
room. You might find that your pointing accuracy will improve if you get closer to
the screen. Also, avoid standing too far off from either side of the screen.
room. You might find that your pointing accuracy will improve if you get closer to
the screen. Also, avoid standing too far off from either side of the screen.
Avoid Shadows!
The wand won't work if its sensor is in a shadow or if it is pointing at a shadow:
Correct (no shadow)
Incorrect (shadow)