Справочник Пользователя для Nautilus International Control & Engineering Ltd NRM-900-1
User Manual
(2009)
Rev
1.0
Page 6 of 6
19/11/09
Nautilus International Control & Engineering Ltd.
The host system shall also ensure that no wire or cable can touch any exposed part of the
module.
The module shall be operated under following environmental conditions:
module.
The module shall be operated under following environmental conditions:
Parameter Min
Max
Temperature, deg. Celsius
-10
60
Humidity, %
10
90, non-condensing
2.2.6
Labelling and FCC Identificator
The module shall have the FCC ID label printed on the bottom side of the PCB. This label shall
contain the following information:
contain the following information:
-
FCC ID: I6I-NRM-900-1
- Manufacturer:
NAUTILUS
The module shall be assigned the following FCC ID: I6I-NRM-900-1 Module
Programming
All operating parameters of the module are programmed into it during system start-up by the
firmware running on the host microcontroller.
The module employs the CC1101 integrated transceiver chip by Texas Instruments.
For the detailed description of this chip, necessary to develop the control firmware, the system
designer is referred to the CC1101 datasheet published by TI as document number SWRS061E.
The firmware design shall ensure that the end user cannot change the module’s operating
parameters and functions beyond those designed at Nautilus and tested for compliance with all
applicable FCC rules.
firmware running on the host microcontroller.
The module employs the CC1101 integrated transceiver chip by Texas Instruments.
For the detailed description of this chip, necessary to develop the control firmware, the system
designer is referred to the CC1101 datasheet published by TI as document number SWRS061E.
The firmware design shall ensure that the end user cannot change the module’s operating
parameters and functions beyond those designed at Nautilus and tested for compliance with all
applicable FCC rules.
2.2.7 Notice for RF Exposure
The module shall have apart 20cm from user for RF safety.