Справочник Пользователя для ZyXEL Communications Corporation NBG2105

 Chapter 13 Wireless LAN

NBG2105 User’s Guide

The following table describes the labels in this screen.

Click Show Active Clients in Wireless LAN > Basic to show the clients connected to the 
NBG2105.

Wireless LAN > Basic: Show Active Clients 

Wireless LAN > Basic

Disable Wireless 
LAN Interface

Select this to disable the wireless LAN interface.

Network Mode

Select the frequency band and wireless network mode for your network.

SSID

Enter the SSID (Service Set IDentity) to identify the service set with which wireless 
clients are associated. Enter a descriptive name (up to 32 printable characters found on 
a typical English language keyboard) for the wireless LAN. 

Channel 

Bandwidth

Select the wireless channel width used by NBG2105.

A standard 20 MHz channel offers transfer speeds of up to 150 Mbps whereas a 40 MHz 
channel uses two standard channels and offers speeds of up to 300 Mbps. 

40 MHz (channel bonding or dual channel) bonds two adjacent radio channels to 
increase throughput. The wireless clients must also support 40 MHz. It is often better to 
use the 20 MHz setting in a location where the environment hinders the wireless signal. 

Select 20MHz if you want to lessen radio interference with other wireless devices in 
your neighborhood or the wireless clients do not support channel bonding.

Channel 

Selection

Select a channel number. The channels you can select depend on the frequency band 
and the country you are in.

Broadcast SSID

Select Enabled to broadcast the SSID or Disabled to hide the SSID in the outgoing 
beacon frame so a station cannot obtain the SSID through scanning using a site survey 
tool.

Show Active 

Clients

Click this to show the clients connected to the NBG2105.

Apply Changes

Click this to save changes back to the NBG2105.

Reset

Click this to begin configuring this screen afresh.