Справочник Пользователя для ZyXEL Communications Corporation NBG4104
Chapter 12 DHCP Server
NBG4104 User’s Guide
86
12.4 The DHCP General Screen
Use this screen to enable the DHCP server. Click Configuration > Networking > DHCP Server.
The General screen displays.
The General screen displays.
Figure 42
Configuration > Networking > DHCP Server > General
The following table describes the labels in this screen.
Table 32
Configuration > Networking > DHCP Server > General
LABEL
DESCRIPTION
Enable DHCP Server Select the checkbox to enable DHCP for LAN.
DHCP (Dynamic Host Configuration Protocol, RFC 2131 and RFC 2132) allows individual
clients (computers) to obtain TCP/IP configuration at startup from a server. Leave the
Enable DHCP Server check box selected unless your ISP instructs you to do
otherwise. Clear it to disable the NBG4104 acting as a DHCP server. When configured
as a server, the NBG4104 provides TCP/IP configuration for the clients. If not, DHCP
service is disabled and you must have another DHCP server on your LAN, or else the
computers must be manually configured. When set as a server, fill in the following four
fields.
clients (computers) to obtain TCP/IP configuration at startup from a server. Leave the
Enable DHCP Server check box selected unless your ISP instructs you to do
otherwise. Clear it to disable the NBG4104 acting as a DHCP server. When configured
as a server, the NBG4104 provides TCP/IP configuration for the clients. If not, DHCP
service is disabled and you must have another DHCP server on your LAN, or else the
computers must be manually configured. When set as a server, fill in the following four
fields.
IP Pool Starting
Address
Address
This field specifies the first of the contiguous addresses in the IP address pool for LAN.
Pool Size
This field specifies the size, or count of the IP address pool for LAN.
Apply
Click Apply to save your changes back to the NBG4104.
Reset
Click Reset to begin configuring this screen afresh.