Справочник Пользователя для ZyXEL Communications Corporation NWA5123-ACHD

 Chapter 4 Dashboard

NWA / WAC Series User’s Guide

Boot Status

This field displays details about the NWA/WAC’s startup state.

OK - The NWA/WAC started up successfully.

Firmware update OK - A firmware update was successful.

Problematic configuration after firmware update - The application of the configuration 
failed after a firmware upgrade.

System default configuration - The NWA/WAC successfully applied the system default 
configuration. This occurs when the NWA/WAC starts for the first time or you intentionally 
reset the NWA/WAC to the system default settings.

Fallback to lastgood configuration - The NWA/WAC was unable to apply the startup-
config.conf configuration file and fell back to the lastgood.conf configuration file.

Fallback to system default configuration - The NWA/WAC was unable to apply the 
lastgood.conf configuration file and fell back to the system default configuration file 
(system-default.conf).

Booting in progress - The NWA/WAC is still applying the system configuration.

Management 

Mode

This shows whether the NWA/WAC is set to work as a stand alone AP.

Power Mode

This displays the NWA/WAC’s power status. 

Full - the NWA/WAC receives power using a power adaptor and/or through a PoE switch/
injector using IEEE 802.3at PoE plus.

Limited - the NWA/WAC receives power through a PoE switch/injector using IEEE 802.3af PoE 
even when it is also connected to a power source using a power adaptor.

When the NWA/WAC is in limited power mode, the NWA/WAC throughput decreases and 
has just one transmitting radio chain.

It always shows Full if the NWA/WAC does not support power detection. At the time of 
writing, only the WAC6500 series APs support the power detection feature.

Interface Status 
Summary

If an Ethernet interface does not have any physical ports associated with it, its entry is 
displayed in light gray text. Click the Detail icon to go to a (more detailed) summary screen 
of interface statistics.

Name

This field displays the name of each interface. 

Status

This field displays the current status of each interface. The possible values depend on what 
type of interface it is.

Inactive - The Ethernet interface is disabled.

Down - The Ethernet interface is enabled but not connected.

Speed / Duplex - The Ethernet interface is enabled and connected. This field displays the 
port speed and duplex setting (Full or Half).

VID

This field displays the VLAN ID to which the interface belongs.

IP Addr/Netmask

This field displays the current IP address and subnet mask assigned to the interface. If the IP 
address is 0.0.0.0, the interface is disabled or did not receive an IP address and subnet mask 
via DHCP.

IP Assignment

This field displays how the interface gets its IP address.

Static - This interface has a static IP address.

DHCP Client - This interface gets its IP address from a DHCP server.

Action

If the interface has a static IP address, this shows n/a. 

If the interface has a dynamic IP address, use this field to get or to update the IP address for 
the interface. Click Renew to send a new DHCP request to a DHCP server. 

Table 23   Dashboard (continued)