Справочник Пользователя для COOPER INDUSTRIES INC FH1847N

T245 Control System Manual

29

These 4 parameters allow you to use the Receiver/Controller in heterogeneous

valve systems.  Grouping valves requiring different drive frequencies into separate banks,
you can provide each valve with the drive frequency most suited to it.

This parameter allows you to select from up to five load moment limits to match

the exact model of digger derrick on which you are installing the Control System.

These parameters are used to multiply (in percent) the Boom Load Moment

Limit to determine the actual load limit for the boom.  There are two separate factors; one
is for ground operation and the other for platform operation.

When you are adjusting these parameters, the T245/T45 or T247 numeric display

will show the value (in percent) of the parameter you are adjusting, with no pointers
(

LOAD %, DIAG1, DIAG2) showing

This parameter determines the speed of the proportional functions when operated

from the toggle switches on the Emergency Override Panel.

This parameter determines the speed of the digger when operated from the Auger

Shake toggle switch.

This parameter is used to determine if the auger must be stopped while shifting

speeds.  Hydrasync diggers can be shifted “on the fly”, while two-speed diggers cannot.
When the Two-Speed digger is selected, the DIGGER SHIFT functions will
automatically stop the auger, perform a shift, and then restart the auger.

When the T245 Transmitter is holstered in the bucket, the bucket speed will be

automatically set to this percentage of the pole-claw speed.