Справочник Пользователя для Garmin International Inc 02723

• #2 Phillips screwdriver
• Screws, bolts, or cable ties (to secure the transmitter)
• Solderless wire-splice connector or solder and heat-shrink tubing
• RV sealant (optional)

When selecting a location to mount the camera, observe these considerations.
• You should test a mounting location before you permanently mount the

camera.

• Installing the camera higher on the back of the vehicle provides a better

viewing angle.

• The included bracket can be clipped onto a license plate or other similar

surface, or it can be fastened to the back of the vehicle using the included

self-tapping, panhead screws.

The transmitter is not intended to be held or worn on your body while it is in use.

When selecting a location to install the wireless transmitter, observe these

considerations.
• You should test a proposed installation location before you permanently

install the transmitter.

• Some vehicles do not provide constant minimum voltage to the reverse

lamps. You should use an automotive relay when connecting the transmitter

and camera to a power source that does not provide constant voltage.

• Although the transmitter can transmit the video signal approximately 45 ft

(13.5 m), the location of the transmitter can affect this range.

◦ The closer you install the transmitter to the device, the more reliable the

signal.

◦ The signal transmits from the flat front and back surfaces 

À

 of the

transmitter. The transmitter provides the best signal when either flat

surface points toward the receiver.

◦ Dense metal or appliances 

Á

 in the path of the transmitter greatly reduce

the transmission distance.

◦ The fewer solid objects that exist between the path of the transmitter and

the device, the more reliable the signal.

• The fuse holder located near the transmitter is not waterproof. Installing the

fuse holder in a location that is exposed to the elements is not recommended.

• The connector between the camera and the transmitter is not waterproof. If

you make this connection in a location exposed to the elements, you must

make sure that the connection is waterproof.

• If you are installing the camera on a boat trailer or other location that may be

exposed to water, you must waterproof all wiring connections and the fuse

holder in the transmitter cable.

Temporarily secure the camera in the preferred mounting location.

2