Справочник Пользователя для Image Sensing Systems Inc. SX300AN
Chapter 5:
Defining Communications
RTMS Sx-300 User Guide
©2014 Image Sensing Systems Inc.
5-18
4. Once a connection is made, in the right pane you can:
•
Alter communication speed (baudrate).
–
–
115200 bits per second (bps) is the factory default for serial units.
–
Data rates below 9600 are useful where high quality transmission lines
are not available. When using data rates below 9600 bps, the Autoscope
RTMS Sx-300 data mode must be set to STAT to reduce the amount of
data and prevent communication problems. See
are not available. When using data rates below 9600 bps, the Autoscope
RTMS Sx-300 data mode must be set to STAT to reduce the amount of
data and prevent communication problems. See
•
Change whether the connection is RS-232 or RS-485.
•
Activate RTS/CTS handshaking if the cable used for the connection is wired
for it.
for it.
5. When finished, click Send.
NOTE: Once you change the settings, you may lose the connection to the Autoscope
RTMS Sx-300. If this happens, enter the connection parameters on the left
side of the screen and click OK.
side of the screen and click OK.