Справочник Пользователя для Audio-Technica Corporation ATH-CKR75BT

2

The product is equipped with a rechargeable battery (lithium polymer battery).

•  If battery fluid gets into eyes, do not rub them. Rinse 

thoroughly with clean water such as tap water and consult a 
doctor immediately.

•  If battery fluid leaks, do not touch fluid with bare hands. If 

fluid remains inside the product, it may cause malfunction. If 
battery fluid leaks, contact your local Audio-Technica dealer.

 

– If fluid gets in your mouth, gargle thoroughly with clean 

water such as tap water and consult a doctor immediately.

 

– If your skin or clothing comes in contact with fluid, 

immediately wash the affected skin or clothing with water. 
If you experience skin irritation, consult a doctor.

•  To avoid leakage, generation of heat or explosion:

 

– Never heat, disassemble or modify the battery, nor dispose 

of it in a fire.

 

– Do not attempt to pierce with a nail, hit with a hammer or 

step on the battery.

 

– Do not drop the product or subject it to strong impact.

 

– Do not get the battery wet.

•  Do not use, leave or store the battery in the following places:

 

– Area exposed to direct sunlight or high temperatures and 

humidity

 

– Inside of a car under the blazing sun

 

– Near heat sources such as heat registers

•  Charge only with the included USB cable to avoid malfunction 

or fire.

•  The internal rechargeable battery of this product cannot be 

replaced by the user. The battery may have reached the end 
of its service life if the usage time becomes significantly 
shorter even after the battery has been fully charged. If this is 
the case, the battery needs to be repaired. Contact your local 
Audio-Technica dealer for repair details.

•  When the product is disposed of, the built-in rechargeable 

battery needs to be discarded properly. Contact your local 
Audio-Technica dealer to learn how to properly dispose of the 
battery.

Warning
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this 
device must accept any interference received, including 
interference that may cause undesired operation.
Caution
You are cautioned that any changes or modifications not 
expressly approved in this manual could void your authority 
to operate this equipment.
Note:  This equipment has been tested and found to 
comply with the limits for a Class B digital device, pursuant 
to part 15 of the FCC Rules. These limits are designed to 
provide reasonable protection against harmful interference 
in a residential installation. This equipment generates, uses 
and can radiate radio frequency energy and, if not installed 
and used in accordance with the instructions, may cause 
harmful interference to radio communications. However, 
there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause harmful 
interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user 
is encouraged to try to correct the interference by one or 
more of the following measures:

 

– Reorient or relocate the receiving antenna.

 

– Increase the separation between the equipment and receiver.

 

– Connect the equipment to an outlet on a circuit different 

from that to which the receiver is connected.

 

– Consult the dealer or an experienced radio/TV technician for 

help.

This transmitter must not be co-located or operated in 
conjunction with any other antenna or transmitter used in 
other systems. This device complies with FCC radiation 
exposure limits set forth for an uncontrolled environment 
and meets the FCC radio frequency (RF) Exposure 
Guidelines. This equipment has very low levels of RF 
energy that is deemed to comply without testing of specific 
absorption rate (SAR).

CAN ICES-3 (B)/NMB-3(B)
This device complies with INDUSTRY CANADA R.S.S. 247.
Operation is subject to the following conditions: (1) This 
device may not cause harmful interference, and (2) this 
device must accept any interference received, including 
interference which may cause undesired operation.
Under Industry Canada regulations, this radio transmitter 
may only operate using an antenna of a type and maximum 
(or lesser) gain approved for the transmitter by Industry 
Canada. To reduce potential radio interference to other 
users, the antenna type and its gain should be so chosen 
that the equivalent isotropically radiated power (e.i.r.p.) is 
not more than that necessary for successful 
communication.
This device complies with RSS-102 radiation exposure 
limits set forth for an uncontrolled environment.