Справочник Пользователя для Movea Inc MPOD3
9
VII.
USAGE
1.
RECHARGING YOUR MOTIONPOD™
The CTRLER must be connected to a computer in compliance with IEC/EN
60950-1 standard. In order to fulfill safety, power must be supplied by a
transformer in compliance with EN standard 60950. Only the MPOD is in contact
with the patient environment.
First connect the CTRLER to the USB port of your computer using the provided cable.
Once the CTRLER is connected, the light indicator “pwr” goes on and gives a green continuous light
(see Figure 2). The two other light indicators are blue diodes which light up along with the first one
once connected to the USB port. They switch off immediately then blink twice to finally go off
completely.
Put the CTRLER horizontally on a table, facet where the logo is imprinted upwards. You can see the
cavity where you can clip the MPOD in. Insert the MPOD by its Black bottom cover directly in the
cavity. The button of the MPOD must be pointing to the Logo. The MPOD must completely fit in the
cavity.
A clockwise rotation of approximately 30° mechanically locks the MPOD in the cavity and therefore
electrically connects it to the CTRLER for recharge. A “click” sound indicates that the system is
suitably locked and started charging (if charging is needed). The whole unit must look like the
photograph on Figure 5.
MPOD encloses a battery. The performance gradually decreases over an
extended period of time (see the number of possible charging cycles).
extended period of time (see the number of possible charging cycles).
In case of extended period of no use, it is advised to check the battery condition
by charging it. If the battery does not charge any more, it is necessary to return
the product to the manufacturer for maintenance (battery exchange). This
operation cannot be carried out by the user. Opening of MPOD (or CTRLER) will
void the manufacturer’s warranty.
by charging it. If the battery does not charge any more, it is necessary to return
the product to the manufacturer for maintenance (battery exchange). This
operation cannot be carried out by the user. Opening of MPOD (or CTRLER) will
void the manufacturer’s warranty.
IMPORTANT (Switzerland): Part 4.10 of the SR 814.013 norm is applicable to
batteries
batteries