Справочник Пользователя для Innovative Control Systems Inc IGWT-660098

If flush mounting is required, use a plastic single 
gang electrical switch box, instead of the 
original white back box (

see Figure 6.3

). A flush 

mount box can be obtained from your local 
building supply outlet. 

 The Keypad manual shows the use 

of a standard single gang, metal electrical switch 
box. Accutech does not recommend the use of 
this type of box for two reasons: 

1.  The fit is very, very tight. If the wires 

are stripped a little “long” as they enter 
the terminal block they may short to the 
side of the metal box. 

2.  If this is not new construction and an 

electrical box with “zip” mounts is to be 
retrofitted in the wall, these zip mount 
tabs may actually protrude into the box 
and then it will be impossible to fit the 
Keypad circuitry inside the box. 

If a metal box is required, you will need to find a 
single gang box fitting the dimensions indicated 
in Figure 6.3. You may find it easier to use a 4” 
square metal box and then use one of the many 
varieties of face plates available from your local 
building supply outlet that will accommodate the 
Keypad.