Справочник Пользователя для HID Global Corporation SE3200
8
Regulatory
8.1
RoHS
The SE32XX RoHS Declaration is located from the iCLASS SE Reader micro-site.
8.2
REACH
The SE32XX REACH Letter is located from the iCLASS SE Reader micro-site.
8.3
Safety
The following describes HID iCLASS SE Reader module regulatory guidelines.
•
UL Recognition (Recognized Component) to UL294 for the USA and CSA
C22.2 No. 205 for Canada. The mark is cRUus where the R is backwards.
•
OEM Final Product UL Listing
Because HID OEM Modules are cRUus recognized, UL treats them as a recognized
component and therefore must be evaluated by UL in the final product for UL Listing.
•
Transient surge protection (transorbs) is not provided for the SE32XX module.
•
The iCLASS SE Reader module is intended to be part of a reader. The reader
in which the iCLASS SE Reader module is used must translate the 3 VDC
module Voh signalling to 4 to 5.5 VDC Voh SIA AC-01 (1996.10) signalling
requirements.
The UL File for the iCLASS SE Reader Module is BP6568, Category Code ALVY2. View
8.4
Product Radio Certifications
The iCLASS SE Reader Module was tested under the FCC rules and Industry Canada rules
for a Modular Approval and therefore the following shall apply: (reference below FCC/IC ID)
•
Provided that the Antenna, Antenna to module cable and tuning network have not
been changed in any way, the Final Product label may contain the FCC ID.
Provided no other radio devices exist within the final assembly.
•
•
The End User/Manufacturer, will not need to repeat the intentional emissions testing
(actual radio certification), however the un-intentional emissions testing will need to
meet the FCC and IC requirements with the module installed into the final assembly
or product. This also applies to CE Marking as defined by the R&TTE Directive.
•
However, in many cases, the module may need to be retuned, due to the affects of
the product enclosure and assemblies within this enclosure, and the de-tuning affect
that this may have on the radio circuitry. In this case and if other radios exist, C2PC is required
•
In the event that the HID OEM modules Kit is modified in any way, the radio
transmitter operating at either 125 kHz or 13.56 MHz and the module is integrated
into the OEM’s final product, Radio Certification is required for the final product.
•
Obtain FCC Certification by submitting the final product to a Telecommunications
Certified Body (TCB) laboratory that performs the testing and issue the FCC Grant.
Standard: Part 15, Subpart C.
FCC ID: JQ6-SE3200
IC ID: 2236B-SE3200