Справочник Пользователя для HID Global Corporation 4045
ENTRYPROX – 4045-907 REV A
34
CHANGING OPERATING PARAMETERS
CHANGING OPERATING PARAMETERS
Many users will use the EntryProx with the factory default
operating parameters. The following commands include
some of the most commonly customized parameters. For
further refinements on EntryProx operation, review the
options shown in Table 2.
operating parameters. The following commands include
some of the most commonly customized parameters. For
further refinements on EntryProx operation, review the
options shown in Table 2.
CHANGING THE MAIN RELAY TIME
The main relay time applies to all users 1-2000. The factory
default main relay time is five (5) seconds. Main relay time
can be set from one to ninety-nine seconds in one-second
increments using Command 11.
default main relay time is five (5) seconds. Main relay time
can be set from one to ninety-nine seconds in one-second
increments using Command 11.
1. Place the EntryProx unit in program mode. Press:
99 # Master Code * (default is 1234)
2. Enter the new main relay time, in seconds (from 1
to 99). For example, to enter 10 seconds, press:
to 99). For example, to enter 10 seconds, press:
11 # 10 # 0 # **
3. Press * to exit program mode.
INVALID PIN LOCKOUT
Command 30, Option 18 allows you to enable or disable the
Invalid PIN Lockout (IPL) feature. This feature prevents
unauthorized persons from gaining entry by guessing PIN
codes or Master Codes. When a preset number of invalid
entries is exceeded (set by using Command 32 – option 4,
default is 5) the EntryProx will either trigger the Forced Door
output, or the keypad will be disabled for a user-configurable
time period (select the action, using Command 30, option 19,
and then set lockout time by using Command 32 – 5).
The invalid PIN code count is reset to zero by any of the
following:
Invalid PIN Lockout (IPL) feature. This feature prevents
unauthorized persons from gaining entry by guessing PIN
codes or Master Codes. When a preset number of invalid
entries is exceeded (set by using Command 32 – option 4,
default is 5) the EntryProx will either trigger the Forced Door
output, or the keypad will be disabled for a user-configurable
time period (select the action, using Command 30, option 19,
and then set lockout time by using Command 32 – 5).
The invalid PIN code count is reset to zero by any of the
following:
entering a valid keypad PIN
presenting a programmed Prox card
entering a valid [ 99 # Master code* ] sequence
the expiration of the keypad timer
presenting a programmed Prox card
entering a valid [ 99 # Master code* ] sequence
the expiration of the keypad timer