Справочник Пользователя для HID Global Corporation 4045
ENTRYPROX – 4045-907 REV A
4
DEFAULT SETTINGS
The EntryProx unit is shipped with the following default
settings.
settings.
PARA
PARAMETER DEFAULT
SETTING
Master Code (User Location 1) 1234*
Main Relay energizes for
5 seconds
Audible Keypress Feedback
ON
Local Propped Door Sounder
activates after
activates after
30 seconds
Local Forced Door Sounder
activates immediately for
activates immediately for
10 seconds
Printer Output Port
Infrared (IR) port
METER DEFAULT SETTING
INSTALLING ENTRYPROX
You can install the EntryProx unit by using a standard
installation method or a secure installation method. Both
installation methods require that you mount the EntryProx
unit to a wall or glass surface.
installation method or a secure installation method. Both
installation methods require that you mount the EntryProx
unit to a wall or glass surface.
ASSEMBLY PARTS
Before you install the EntryProx, be sure that you have the
correct factory and installer supplied parts.
correct factory and installer supplied parts.
A. Controller Keypad Unit
I. Silicone Rubber Cushion
B. Controller Keypad Backplate
J. Self-Adhering Pads
C. Cable Assemblies
K. 2-pin Jumper
D. Antenna Backplate
L. Filler Piece
E. Antenna Housing
F. Blank Label
F. Blank Label
M. Lithium “Coin Cell”
Battery (see warning below)*
Battery (see warning below)*
G. Mounting Screws
N. Cover screws – hex and
tamper.*
H. Press to Exit Label
O. Hex wrench*
* - not shown in Figure 1