Справочник Пользователя для Microtek Electronics Inc WES

 

 

PROBLEM SUGGESTION 

No Link Activity 

1.  NO POWER – make certain the both 

WEMs have power and the red Power LED 
is on. 

2.  Check the configuration of both WEMs.  

Each pair must be set to the same address.  
If you have changed any of the advanced 
settings, make sure the configuration of 
both WEMs is the same. 

3.  Make sure the cable run between the WEM 

and Ethernet device is no longer than 328 
feet. 

4.  Make sure the cables being used are 

straight through and all cable connectors 
are attached properly. 

5.  If using an Ethernet hub or fast switch, try 

a crossover cable between the hub and the 
Power Injector Module.  

No Signal Level LED 
or Flashing Signal 
Level LED 

1.  Check line-of-sight of the WEMs.  Verify 

the WEMs are aimed properly.  You 
should have clear, wide-open line of sight 
between the WEM modules. 

2.  Change channels; cycle power. 

All three solid LEDs 
but no picture 

1.  Check video at the camera 
2.  Check wiring into encoders or decoders 
3.  Try changing channels; cycle power 
4.  Hook up one radio directly into a PC or 

laptop and verify that the IP address is 
accessible. Check the other radio the same 
way, then verify that each IP address is 
accessible over the wireless link into a 
PC/laptop. 

No Green Signal Level 
LED (When Using the 
MLWES-30 with two 
18” Parabolic Dishes) 

1.  Verify wide-open line-of-sight 

2.  Re-angle your dish antenna in a downward 

angle until both LEDs are solid green.  

3.  Mount the dishes higher above ground 

level and/or above any obstruction.  

 

If you have tried the trouble shooting steps above and the system is still not working correctly, 
please contact MicroTek at 888-366-4276, Monday through Friday, between the hours of 
8:00AM and 5:00PM Pacific Time.  One of our technicians will work with you to rectify the 
problem over the phone. 
 
Thank you, 
MicroTek Electronics, Inc.

 

 
 
 
 

- 14 -