Справочник Пользователя для JVC KENWOOD Corporation 412900

Скачать
Страница из 54
3   Align the two tabs at the bottom of battery case, then close the cover until the 
locking tabs on top click.
4   To install the battery case onto (or remove it from) the transceiver, follow steps 
 to  of “INSTALLING THE BATTERY PACK”.
Note:
u
  Do not use Manganese batteries or Rechargeable batteries in place of Alkaline batteries.
u
   Always replace all batteries at the same time.  Mixing old and new batteries or mixing types 
(such as Alkaline with zinc carbon) will reduce the overall performance and could cause 
leakage or rupture.
u
   Remove all batteries from the case when it is not expected to be in use for several months.
u
   The voltage of new Alkaline batteries varies slightly, depending on the manufacturer.  Thus, the 
high battery power indicator may not appear even though new Alkaline batteries are installed.
u
  To lift the battery pack safety catch, use a piece of hardened plastic or metal, such as a 
screwdriver, that is no more than 6 mm wide and  mm thick. It is imperative that you place the 
implement under only the lip of the safety catch so that you do not damage the release latch.
INSTAllINg ThE BElT clIP
If desired, you can install the supplied belt clip to the transceiver.
1  Loosely insert the two supplied screws into the holes on the back panel of the 
transceiver.
2  Slide the belt hook into position, under the screws.
3  Tighten the screws until secure.
Note:  When the belt hook is not attached to the transceiver, remove the screws from the 
transceiver to avoid scratching other materials.