Справочник Пользователя для EMS Technologies Canada Ltd. HSD-X
Page 4–12
18 September 2007
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
Figure 4–12. Level 2, Menu 15
Figure 4–13. Level 2, Menu 18
Note:
In control processor software, version 7.0, Menu 18 is available when the
terminal category is set to HSD-X Network, HSD-X Antenna, or Viper
configurations.
terminal category is set to HSD-X Network, HSD-X Antenna, or Viper
configurations.
(6) Menu Item Descriptions
This section provides a brief description of the Level 2, maintenance-utility-program
menu items used for test and fault isolation procedures.
menu items used for test and fault isolation procedures.
Although this section only provides illustrations and descriptions for Level 2 access,
descriptions of all Level 1 access menu items shown in Figure 4–5 are covered. (All
Level 1 menus are included in Level 2 Menus.)
descriptions of all Level 1 access menu items shown in Figure 4–5 are covered. (All
Level 1 menus are included in Level 2 Menus.)
In active HSD systems, menu screens display the firmware version.
Note:
Depending on the version of software installed, the number of channels
cards in the system, and the HSD configuration mode, the menu and report
items available to users may differ slightly from the illustrations shown and
described in this document.
cards in the system, and the HSD configuration mode, the menu and report
items available to users may differ slightly from the illustrations shown and
described in this document.
(a) Menu 1
Figure 4–14 shows the HSD maintenance utility program Menu 1 screen display.
Table 4–7 describes the items available in Menu 1.
Table 4–7 describes the items available in Menu 1.
In control processor software, version 7.0, the following changes were made to
menu 3 selections (delta between version 4.5 and 7.0). No additional menu items
were added with the release of Version 7.5, Control Processor software.
menu 3 selections (delta between version 4.5 and 7.0). No additional menu items
were added with the release of Version 7.5, Control Processor software.
•
Added menu items, S ‘set hcm attenuator’ and R ‘ hcm RF threshold’
MENU 15 FIRMWARE V7.0
V request channel card versions D channel card serial number
<CTRL> N next menu <CTRL> O previous menu = select reports
MENU 18 FIRMWARE V7.0
X HSD-X slave console mode B HSD-X slave cable loss
L list HSD-X slave cable loss V get HSD-X firmware version
L list HSD-X slave cable loss V get HSD-X firmware version
<CTRL> N next menu <CTRL> O previous menu = select reports