Справочник Пользователя для EMS Technologies Canada Ltd. HSD-X

To display the versions of software loaded onto the HSD, press V.

A list of Firmware Versions appears similar to the example provided below (actual 
versions will differ depending on the versions of software installed on the 
transceiver).

HSD units with two channel cards also list the firmware versions for 
Channel Card #2.

Verify that all software has successfully loaded. In two-channel card units verify 
that the software has loaded successfully to both channel cards. Verify that the 
software versions (Firmware Versions) shown, match the versions listed on the 
load disk (or files) and in the software service bulletin.

Close the HyperTerminal session.

Remove power from the HSD.

Turn off the computer.

This completes the software load verification. The next section explains how to 
disconnect the software load equipment.

(6) Disconnecting Load Equipment

After completing all required software loads and load verification: 

Remove power from the HSD (if applicable).

Turn off the computer (if applicable).

Disconnect the serial cable connector from the computer 

 

COM port.

Disconnect the serial cable connector from the HSD Maintenance Port.

      MENU2                             FIRMWARE Vx.x

A     set veh-relative azimuth          E     set veh-relative elevation
K     desired az veh-rel velocity       R     resume automatic steering
T     enter time of day                 N     annotate log file
L     re-enter logon password           V     get firmware versions
Z     reset HSD-128
<CTRL> N  next menu      <CTRL> O  previous menu  = select reports

FIRMWARE VERSIONS:
   KERNEL:          V1.6 -- Mon Oct 07 13:36:26 2002
   APPLICATION:     V4.1 -- Thu Oct 10 08:36:29 2002
   CHANNEL CARD #1: 0.5.4.0 9040 -- 0.0.0.30 -- 1.8.0.A
   CHANNEL CARD #2: 0.5.4.0 9040 -- 0.0.0.30 -- 1.8.0.A
   HPA:             S/W P/N: A1703706 Ver: V1B1-Unit #00043 F/W Ver: V5 
   DATA I/O CARD:     -- MAY BE TYPE 1