Справочник Пользователя для EMS Technologies Canada Ltd. HSD-X
Page 2–17
18 September 2007
SYSTEM DESCRIPTION, INSTALLATION, AND MAINTENANCE MANUAL
eNfusion™ HSD-128 High-speed Data Terminal
3.
Type 9 for Cooperative Rockwell-Collins SAT-906 and then press Enter.
A system message appears stating that the EEPROM has been updated.
(b) Configuring the Number of Channel Cards
HSD transceivers operating in Cooperative Mode must be configured as
single-channel units—even if the unit is a dual-channel transceiver.
single-channel units—even if the unit is a dual-channel transceiver.
To configure the transceiver as a Single Channel system:
1.
In Menu 3, press M.
2.
Type 10 to select the “Number of Channel Cards” parameter and then press
Enter
Enter
.
3.
Type 1 for the number of channel cards and then press Enter.
A system message appears stating that the EEPROM has been updated.
This completes the configuration of the system’s number of channel cards.
This completes the configuration of the system’s number of channel cards.
You now need to configure the LES Access Codes as described in
"Configuring LES Access Codes (All Modes)" on page 2-24.
"Configuring LES Access Codes (All Modes)" on page 2-24.
(3) Configuring System Parameters for Honeywell Combined Mode
To operate the HSD transceiver in Honeywell Combined Mode, you need to configure
the following system parameters using the Honeywell SATCOM Direct
Commissioning and Maintenance Terminal (CMT) and the HSD Maintenance Port
Utility.
the following system parameters using the Honeywell SATCOM Direct
Commissioning and Maintenance Terminal (CMT) and the HSD Maintenance Port
Utility.
To configure the Honeywell System Parameters:
1.
First, use the Honeywell CMT to:
•
Obtain the HPA to antenna loss from the Honeywell SDU
•
Configure High Rate Data Support settings (recommended—but not
mandatory)
mandatory)
2.
Then use the HSD Maintenance Port Utility to:
•
Configure the Terminal Category (only required when the recommended
hardware strapping is not used)
hardware strapping is not used)
•
Set Swift64 (M4) and Aero service priorities
•
Change the LES Access Codes
•
Reset the system to activate the new configuration.
TERMINAL CATEGORY HW STRAPPED VALUE
0=SAT906 1=STANDALONE 2=HW STRAPPING 3=MCS3000 4=MCS6000 5=MCS7000
6=MCS COMB 7=STANDALONE W/O ANTENNA 8=HCM COMBINED
9=COOPERATIVE ROCKWELL-COLLINS SAT906 10=OLD COMBINED MODE DEVELOP
11=HSD-X NETWORK 12=HSD-X NETWORK W/O ANTENNA 13=VIPER
0=SAT906 1=STANDALONE 2=HW STRAPPING 3=MCS3000 4=MCS6000 5=MCS7000
6=MCS COMB 7=STANDALONE W/O ANTENNA 8=HCM COMBINED
9=COOPERATIVE ROCKWELL-COLLINS SAT906 10=OLD COMBINED MODE DEVELOP
11=HSD-X NETWORK 12=HSD-X NETWORK W/O ANTENNA 13=VIPER
NEW TERMINAL CATEGORY = ? 9